Ability to insert a series of event points, e.g., every 25 m along axis, in a single shot at once

When placing an "angle point" in between 2 tangents in track, we need the ability to annotate what the angle value is between the 2 bearings.

I need a closed linear survey element to populate the area in the element information. I'm wanting to create a civil label that will place the area of a closed shape. As far as I can tell, this will work except with survey elements.

In the old Geopak we could create superelevation shapes to follow a profile grade line (we called this a "PGL Chain". In locations where the lanes transition offset, this helped us to see that the lanes transitioned offset while still following st...

For large scale projects, earthwork volumetric meshes cause considerable deficits in navigation performance due to the high count of vertices and faces to be calculated with each navigational operation. Use of scalable meshes for these components ...

When designing drilled shafts, there is no option to display controlling shear and moment loads (bottom of column). This is needed for the geotechnical engineer on designing th drilled shaft. For column design, it is sometime useful to also show c...

It could be useful for different purposes to be able to create component meshes of defined length (construction, pre cast slab). I suggest to add at least 3 parameters to any component: length of the component: the question is then, where to measu...

This code would be similar to the DIST command, except it would allow the crews to add a taped distance to the last segment of a figure, which would extend that segment by that value. It would be similar to a DIST commend except instead of turning...

The Sigle Point Arc command in InRoads survey would create true tangent arcs from the incoming and outgoing tangents. The ArcSingle in Open Roads does not. This frequently results in bulges in figures if the uncoded PC and PT points are not perfec...

This code was found to be very useful in InRoads Survey and without it, we need to retrain the crews to change their workflows.