Similar to the custom tools for available for stiffeners and cross frames for steel built up or rolled shape beams, OBM needs to add tools for adding these to steel tub/U beams

At the moment, you run Place Node, then set the type of node by picking a feature definition. However, you normally know what type of node that you want to place, such as a manhole for example,so it would be more intuitive if the ribbon contained ...

Add a separate limiting tension stress for the top of girders near interior supports. AASHTO LRFD permits the use of a limiting tension stress at the top of girders near interior supports for Service III different than the limiting tension stress ...

The Florida I-Beam (FIB) section library in LEAP Concrete has not been updated to reflect the latest standard revisions. In particular, the number of strand slots in the third row from the bottom (@ 7") is shown as 13 in LEAP, while the current st...

Special Node/Option for Full recognition (reading civil information) and creation of Feature Definitions in GenerativeComponents. GC & Civil Packages would benefit greatly if we could automate the creation of Civil Lines (2D/3D) for subsequen...

Currently, when importing text files to fieldbooks the directory opens in the last used directory. It would be useful to control this behavior so that it can open in the directory where the active DGN is located. This can function similar to the c...

Add ability to create picklist that we can associate value to it. In parametric contraint we could chosse a parameter and this parameter have a pick list. This pick list could be associated to a value list and we could use it for dusply rules or o...

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...

When using a circle or an arc in a template component, the software is building linestrings on default level in the 3d model. It is possible to turn off these lines if the Null Point Linear Feature Option is set to False in the template feature de...

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...