PowerInroads used to have a built in calculator/analyzer. It helped us to quickly calculate the drainage pipe information, minimum slope and velocity at full value etc. Currently to get the data, we use Flow Masters and manually calculate each pip...

RIght of Way take tables are required with named points. The normal workflow is to create points then origin point persist snap those elements creating the shape of the deed boundary to the points. In this way the legal reports show the point name...

When annotating elements using an affix (prefix or suffix) tied to a Text Favorite, OpenRoads currently annotates the affix even if the Text Favorite evaluates to a blank or null value. This results in: Stray symbols, separators, or units (e.g.,...

Service load cases are optional for legal and permit vehicle ratings for prestressed girder structures, but are required for the design vehicle. Currently, two analysis runs must be done to get ratings for design, legal and permit vehicles; one ru...

Make Cross Section to Surface tool available on newer versions of OpenRoads Designer. This tool was available on InRoads.

The following idea is related to the survey tool gap analysis that is already being considered. The Extract Contour tool should be enhanced to place a graphic line at a specific elevation. Currently, you have to change the contour interval of my t...

To enhance productivity and efficiency in live projects, we need dynamic Named Boundaries linked to Geometry. This includes the ability to update the shape or location of a named boundary after creating a sheet model, with the changes reflected in...

There should be an item type expression available that can provide the station to station extents of an element. Currently Bentley provides expressions for begin and end Station that correspond to the stationing at the beginning and end of the ele...

In Geopak Drainage, once you place a node and attached a catchment, you were able to see inlet calculations. This let the user know if they needed to shift the box to have an allowable spread. It would be great if we could get that feedback withou...

Geopak is no longer supported by Bentley. At some point, Geopak will not be installed on our machines, but we may need to get the calculations that reside in the GDF file. We need a method that will allow us to extract the information we need from...