We can add points to regression line but we can't remove points from regression line.We can ignore but it is not good management especially if you added a wrong point to the regression line that must be added to another regression line. Because th...

Currently in ORD existing cant can only either be viewed graphically in the curvature diagram or from within the cant editor. Current workflows to annotate existing cant in profile require the projection of both left and right rails in the vertica...

As agencies transition from using the survey foot to the international foot, their workspaces in OpenRoads need to be thoroughly reviewed and updated. A critical component of these workspaces is civil cells. However, civil cells do not scale corre...

Possibility to add/remove/change length of long sleepers sets in turnouts that are placed in a geometry. When you are working with existing geometry and there are turnouts with too long sleepers sets or if you by mistake place a turnout that has a...

Catch basins have the following flow types that can be added: additional subsurface flow (cfs), known flow (cfs), additional carryover flow (cfs), external CA (acres), and external Tc (min). Manholes only have the option of known flow. Known flows...

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...

Existing cant annotation is often, if not always, required on profile drawing. Actually we must project rails onto the profile, create aliases, to extract level differences between existing rails whereas the information is fully available from reg...

Allow a checkbox to choose to overwrite or replace existing saved views when re-processing a set of named boundaries for output to sheets. This will help to maintain order in the files and avoid excess unused items. If not creating another 'versio...

The class of a pipe is primarily selected by the depth of cover over a pipe. Sometimes vehicle loads or construction loads have an influence on the class selection

For now ORD Cross sections have limited capabilities compared to MS Clip volumes. Request is that ORD cross sections do inherit full capabilities of MS Clip volumes, including capability to define a thickness for point clouds and project the Point...