I would ensure that my vertical and horizontal alignments are the same length by using the Trim/Extend buttonn in geomtery editior in Power Rail Track - can we have the same functionility in ORD please? I know I can snap vertical alignment to the ...

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...

Existing cant annotation is often, if not always, required on profile drawing. Actually we must project rails onto the profile, create aliases, to extract level differences between existing rails whereas the information is fully available from reg...

It is hit and miss if Civil File Manager can upgrade files containing SS4/10 data. Civil File Manager also cannot remove SS4/10 Civil data. There are still projects on the shelf that were begun in SS10 that now need to be upgraded, or projects des...

Similar to the commands like "Place Temporary Vertical Dimension", have a Right Click command to enable showing the temporary elevation of a specific template point selected such as a Ditch Flowline template point, existing surface at EOP template...

Want: Objects in model would highlight when selected through the project explorer Why: if you have multiple objects say terrains, and you need to modify them, it would be very helpful to see them highlighted through the project explorer. Often tim...

OBM should incorporate a Bridge Objects utility similar to the Corridor Objects in ORD. Having to go back and forth between the Explorer and the Properties panes is a clunky and inefficient workflow especially when you're typically accessing an ob...

I needed to update one point control but I had no idea where I could find the line (plan element) that was used in the point control. The point I could find in the template or by hoving the mouse over the corridor, but the line (plan element) that...

Almost all other Geometry exports now have key ins to export geometry, except GENIO. In many parts of the world this is a primary data exchange and construction deliverable so automation is key to efficiently delivering. Adding a key in that allow...

Currently in the XSection viewer in OpenRoads Designer if you have a corridor or linear template that touches our butts up against another corridor you can't place temporary dimension lines on those components to make measurements if the linear or...