When navigating through all the feature definitions it would be handy to have an option to set the feature to the active definition being used. It's easier many times to navigate through the OpenRoads Standards list to find features than using the...

Provide a user-friendly check integrity tool for dgn files. This tool should show users any potential issues and give them the option to fix it.

When I create a parametric cell library for use in OpenBridge, the library isn't recognized as an option in the Place Bearings tool when working within TXDOT workspace projects. Even though the cells are correctly defined and referenced, they don’...

Instead of a one time thing, create and save the comparison set in a toolbar table. If I want to run again I just need to hit a refresh button for the specifc set. When developing a project, keeping track of cut and fill volumes between design and...

When a dgn contains lots graphics in the active dgn and reference files, I often find it challenging to select the desired alignment for various tools (e.g. tracking, laying out sheets, etc..). to make this easier, I propose that Bentley provide a...

When using the "Create 3D By Slope To Target Tool " the only way to Trim/Extend the resulting linework is to manipulate the start/stop station which is very cumbersome. It would be much more intuitive if a Trim/Extend arrow head (similar to geomet...

Suggest making California design for abutments on LEAP to follow this Live Load Distribution memo. All abutments in California must be designed using the following Live Load Distribution method or it would not be acceptable per Caltrans standards....

The world famious bridge softwares such as Lusas, Midas Civil, Sofistik, Larsa 4D. All of them have been developed Grasshopper Plugin to increase the bridge modeling capacity. Lusas Grasshopper plugin: https://www.lusas.com/products/external_plugi...

Use the Geometry Connector with start and end elements chosen as turnouts. The converged result gives a disconnection between the regression alignment and the turnout. You can only discover it by zooming in to the closest possible view. A "Verify ...

The current connection region of drainage nodes are available for the side faces of node only. The software should allow the connection region of pipe/conduit from the bottom of the node.