The following idea is related to the survey tool gap analysis that is already being considered. The Extract Contour tool should be enhanced to place a graphic line at a specific elevation. Currently, you have to change the contour interval of my t...

all numbers are unitless with the assumption inches are the unit. signs can get wide. allowing for 14'-5" versus 173 or 173" would be a great enhancement.

CS0152823 "This user is suggesting to add a note that our STM analysis and design method is based on which AASHTO Code edition. " To add a note regarding LRFD-9 STM changes in output results report

A tool to move multiple nodes at the same time is needed in ORD as such tool or functionality was not observed with ORD. This is helpful for situations where the nodes will be offset by a certain distance due to the buildings or other constraints ...

Currently, Reports produced with Item Type data do not respect Fences or clipped length. Could Bentley develop a way to get these reports to work with fences? We need a way of reporting quantities for 'dumb' lines with only Item Types attached. Th...

The nesting depth on newly created Drawing and Sheet Models defaults to 99. I have set up my sheets seeds the way that I would like the nesting depth to be set. For Plan and Profile Sheets, the Default model of these sheets acts as the "container ...

each time you close the window, you loose your positionning setting

https://openflows.ideas.aha.io/ideas/SWRG-I-142(https://openflows.ideas.aha.io/ideas/SWRG-I-62) ORD users running an unsteady-state analysis with the CivilStorm license would like a way to display maximum spread width polygons along their gutters.

https://openflows.ideas.aha.io/ideas/SWRG-I-141 ORD users running an unsteady-state anlysis with the CivilStorm license would like a way to display a maximum hydraulic grade line and maximum energy grade line to their profile runs for inclusion on...

When using the Transpose tool, the software makes a copy of the element you are selecting to transpose, and that is the element that is reversed, leaving behind the original underneath. Most of the time I do not want a copy of the transposed eleme...