When using the Transpose tool, the software makes a copy of the element you are selecting to transpose, and that is the element that is reversed, leaving behind the original underneath. Most of the time I do not want a copy of the transposed eleme...

It would be nice to be able to export a drainage network into 2D linework that can be edited for plan sheets. Currently, we don't use our modeled files directly in our plan sheets as we cannot adjust the conduit line styles and it takes longer to ...

File branding by Product is problematic for Organizations where multiple software solution are deployed like OpenSite, OpenRoads, OpenRail and OpenBridge. The schema(s) within the file should be analyzed at file open rather than the last authoring...

It would be helpful to use quick temporary dimensions in the dynamic cross section viewer. You could potentially use annotation groups that are set up for the cross-section sheets and quickly toggle them on and off, labeling the important features...

when a single-station edit to a cross section is made, it is disassociated to the baseline alignment. Therefore, if the baseline horizontal or vertical alignment is edited after this, the single station edit does not dynamically update to the new ...

Allow for an OBM bridge to utilize bridge components from a referenced OBM file to create geometry. Example: A project requires parallel design for steel and concrete beams. Allow OBM "File A" to contain the alignment, profile, deck, and steel bea...

In LEAP substructure modules, it would be helpful to be able to add loads to the footing, other than vertical earth. Sometimes there are miscellaneous components of the pier/abutment where the weight needs to be considered, but are not a part of t...

We need the software to have capability in reporting to interpolate lift and slew values between regression points. Because currently when a complex alignment end point is between regression points the reporting only picks up the lift and slew val...

When you create earthwork, there is a way to create an additional quantities for rock excavation and unsuitable material. We are wanting to be able to run the earthwork EAV report to have those quantities in EAV format, and then be able to annotat...

surface templates apply depth vertically, in many cases it is desired a true depth that is perpendicular to the terrain.