When you initially create a drainage area from a shape, it creates 'smart' vertices that you can grab and move with the cursor. However, after the initial catchment shape is created, the only way to add additional vertices is using the "Insert Ver...

We often do sheets where the same station range is shown, plan on top and bottom, but they have different information. For instance, the top plan view might be a staking overview where the bottom plan might be a jointing diagram. Both have the sam...

Currently OpenRail does not have the ability to assign profile symboligies for Turnouts with the Turnout Feature Definition.

This addition would allow a truck other than the AASHTO Fatigue truck to be checked for the fatigue load case when the design criteria require a different truck. Currently, it is NOT possible to check the fatigue load case for a live load other th...

Right now in our plan and profile drawing seed files, we can only anchor a clip boundary from its left-most point. This works if users always place the same linear distance on each sheet, but if the user wants to vary the project length shown on e...

Developing turnouts in the new software can be quite cumbersome. If there was a wizard that allowed users to input known common pieces of geometry in a more descriptive and graphical fashion, it would help significantly. When geometry elements are...

We need the ability to annotate component quantities on cross sections like you can the cut/fill volumes. Information could be pulled from the Quantities Report by Named Boundary.

This is a request to enhance the annotation groups. Can there be a toggle in the annotation group to have the ability to group the different annotation definitions together. For example, we have lots of annotation groups that have multiple text fa...

It would be great if ORD had the capability to connect a channel directly to an On Grade Inlet to be able to calculate spread and bypass at the inlet. Currently the workaround is to connect the channel to a Generic Outfall at the edge of the inlet...

and not just a basic triangulation of 3D lines. Maybe add transverses features.