Currently, when one uses the create regression line from rails tool, the points that the program creates are 2D, in other words they contain only X and Y, not Z. It would be nice to create points along with the regression line that contains also i...

It is often required to annotate slope along sublayers. Typical example is to annotate the top of the subballast in track design. The expression allows to do many things but it doesn't work as expected.Even you specify the point names such as L_Su...

Much like the "Break Void" line where the elevation of the graphic is honored in the Terrain, a "Break Island" should also exist to prevent improper triangulation.

OpenRail now looks like it is behind the 12D Model, after removing good design functions in BRT. In OpenRail, it is hard to have multiple alignment options. For example, you can copy a horizontal design, it will carry a profile, but not cant desig...

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...

OpenRoads should have a Command that place a line between two imported points (.asc, .crv, .txt file) V8i does have a command that will place a line between two imported points. After importing the points into the drawing, you click on the "line c...

OpenRoads uses different types of file open dialogues throughout the program. The first type allows the user to paste a file address directly into the navigation bar. The second type does not allow the user to paste the file address and forces the...

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...

In Rail track engineering, it is common to have an existing track and a client wants to modify its geometry, but only partially. That means that parts that are changed VS parts which remain unchanged should be marked with different FD. However, on...

A couple suggestions for this tool: 1) Be abl e to see the dynamic slope line without first placing a line. I have to click somewhere in my file for it to place the line in the 3 D model before I am able to see the line at all. After this line is...