Allow target aliasing to be used for regular corridor components, points, etc. in addition to end conditions. A specific scenario where this would be useful is setting up a secondary corridor that needs to be editable but also follow the exact geo...

It is my understanding that this was removed in the 2024 version due to general confusion, but I'd like it to be added back. If it is made toggleable, it can be turned off by default to avoid the aforementioned confusion, and this allows those tha...

I created the Civil Label for the 100’ elevation along a geometric element, but I want to be able to pick where the labeling starts and not at the start of the geometric element. I want to establish a target to start the 1st label at a prompted cl...

We create typical cross sections as part of our plan set. I've seen guidance from Bentley on how to use different parts of the 3D corridor model to cut cross sections in specific places and then use those cross sections as the typical cross sectio...

Would be beneficial to be to add overlaps to profile named boundaries so they match the plan sheets. Would like for this to be an automated option when creating profile named boundaries based from the Plan sheet named boundaries.

When the connection plates or stiffeners are placed, they are appearing half-embedded into the web with an equivalent gap on the opposing edge. For it to actually be correct, the plates should be beveled to match the vertical face of the web.

We currently have visual graphics to show us a KEY STATION or a POINT CONTROL has been added to your corridor. A visual graphic or notation that a template drop has been edited would be a nice addition. Also, maybe add the ability to add a short n...

MnDOT would like to set a network location for the standard libraries. This way every user gets the current design. OpenRoads SignCAD does not currently support UNC paths or writing a conditional in the OrganizationSetting.cfg file. It seems illog...

In the Cant Editor, there is a tool called validate data which allows you to add in your design parameters and then check against the cant the Openrail has already automatically generated. although a good tool, i just think it would be better Open...

With Inroads Survey, whenever XYZ coordinates needed to be entered for a particular purpose, a screen-pick option was always available. (see attached image) This was extremely useful. However, with ORD, changing the XYZ coordinate of any points in...