A standard Pier type used in our state typically calls out two lengths of pile ('Long' and Short') that alternate along the width of the Substructure. An example plan is attached. If the ' Embed Length ' variable had a manual override option to ch...

I would like the ability to change the Feature Name of an element that is part of a Complex Element without having to drop the Complex Element.

When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...

As in the geometry connector, the geometry builder needs to be able to fix certain elements

Add a separate limiting tension stress for the top of girders near interior supports. AASHTO LRFD permits the use of a limiting tension stress at the top of girders near interior supports for Service III different than the limiting tension stress ...

The Florida I-Beam (FIB) section library in LEAP Concrete has not been updated to reflect the latest standard revisions. In particular, the number of strand slots in the third row from the bottom (@ 7") is shown as 13 in LEAP, while the current st...

Currently, the software does not respond to removing element annotation in the profile drawing models. Instead, the entire model needs to have annotations removed, re-annotated, and then the individual elements need to be annotated.

We need better access and configuration for this constant. There is no place to set this constant.

Add ability to create picklist that we can associate value to it. In parametric contraint we could chosse a parameter and this parameter have a pick list. This pick list could be associated to a value list and we could use it for dusply rules or o...

It will be helpful to see where the clipping is coming from. Example if reference file then would be helpful to know what reference file