Currently, the "Analyze Volume" tool "Only" allows you to use an ORD Geometry Shape for a boundary. It would be much more useful and intuitive if we could also use a fence and/or a regular MicroStation shape for a boundary as well like you could w...

Superelevation is a tabular note that goes on the general info sheet with the super elevation diagram, so we usually just fill out the info in that tabular note. Designers just blow up the tabular note to add lines and make it work per project. If...

In ORD when you attempt to measure the graphics within a XS View it appears that you get the surface area of the entire cut or fill volume. As a user, I need the specific end area for the element. Presently you have to trace the element with a mea...

For Steel bridge modelling, for the beam definitions, the only possible options are defining rolled or built-up shapes or defining Tub Girders. It would be very beneficial to have an option or steel beams to define custom cross sections similar to...

it would be more accurate to calculate the structure Height if when a pipe is connected to a structure that the bottom base slab was adjusted to be below the wall of the pipe. this would also make the 3D model look better.

Civil Labels can get dissassociated for a number of reasons. When this happens, the user often deletes the text that turns dashed. This, however, does not delete the circle associated with the text. Due to this, the remnant circle is left. This ca...

Currently, is possible to create and personalice reports (Analise)using Item Types data, however,there is no relation back. It would be very benifecial if data added or even changed into the reports could be imported back into the model and Item T...

Currently, in LEAP Steel, haunch self-weight is a system-generated load in the initial stage, so LEAP applies the load over the whole bridge. I recommend changing it to be a staged load like the deck slab self-weights, since haunches are poured co...

The ability to bulk change survey features of points. This would quick way to change features if features are in one standard to another.

Would be very helpful to get some kind of warning that pops up when someone tries to import geometry from an xml file where the chord/arc defined on some of the xml file geometry is different than the “degree of curve method’ setting assigned to t...