It would be useful to have the ability to annotate only part of the horizontal alignment. There are situations where we need to have several different annotation groups along the alignment.

We would like to be able to set up annotation groups to annotate the invert and/or crown elevations of a conduit along its length using set station intervals. Currently, there are only start/end invert/crown elevation text favorite fields.

I want to be able to annotate the element item type properties attached to linear features displayed on cross sections and profiles using annotation groups. Currently any text favorites created from item types do not resolve to show the item type ...

We are now 10 years into OpenRoads. Why are we still faced with two property panels. One for MicroStation and one for Utility/drainage. The two property panels overlap in what is displayed. ELIMINATE the Utility Properties Panel so we can end the ...

If you check the "Do not Show Again" box and press OK to the warning message in OpenRoads SignCAD 2023, then you can add additional panels to the file without the warning message displaying. However, closing and reopening the file will cause the m...

I would be helpful in many chases to be able to set Huanch to be above Top Flange of Steel Beam, or even to set it in any place of Beams Hight.

I have brought the limitation to the Wind Load Auto Generation tool in the past, but this is becoming more important and an issue now, since I’ve been getting many comments from our clients and my coworkers on this. Currently, the wind load auto g...

Currently in ORD existing cant can only either be viewed graphically in the curvature diagram or from within the cant editor. Current workflows to annotate existing cant in profile require the projection of both left and right rails in the vertica...

Product will not allow me to change variable constraints on my approach slab template with my support line placed on a skew and the relative location is behind that support line. I can't use negative numbers from the support line and I can't used ...

The ability to place a conduit with multiple barrels is very useful. However, there are many scenarios where a single node is needed on each of the multiple barrels. Instead of modeling the pipes individually or creating custom twin-node workaroun...