We currently only have the ability to produce Cut & Fill volume quantities using available text favorites for our cross sections. That's where it ends when it comes to extracting quantities from the model to display in the drawing/sheet models. We are able to produce dimensions with values for Clearing/Grubbing and Seeding/Mulching by utilizing specific points in our templates with annotation groups but no method to produce those same values into a table (cell). The sum of these quantities also depend on reading the NEXT named boundary (section) for distance and volume measurements. We have a complete model with everything needed to construct the roadway but no tools to leverage that data into our plans outside of a report. Attached is an image of the cell we wish to populate. Imagine how many hours/weeks of work this would save on a ten mile project?