Provide a user-friendly check integrity tool for dgn files. This tool should show users any potential issues and give them the option to fix it.

Surface template should allow the selection of any type of shapes, specially with holes. A tool to add new holes post creation would be wonderful too

Similar to the commands like "Place Temporary Vertical Dimension", have a Right Click command to enable showing the temporary elevation of a specific template point selected such as a Ditch Flowline template point, existing surface at EOP template...

The current connection region of drainage nodes are available for the side faces of node only. The software should allow the connection region of pipe/conduit from the bottom of the node.

We need the ability to adjust the Template Drop "Interval" when using the "Apply Linear Template" Tool. Currently this option is only available for Templates which are attached to Corridors, but we need to also have it available for the "Apply Lin...

When a dgn contains lots graphics in the active dgn and reference files, I often find it challenging to select the desired alignment for various tools (e.g. tracking, laying out sheets, etc..). to make this easier, I propose that Bentley provide a...

In the Feature Definition Toolbar, there is a button to "Use Active Feature Definition" This should be enabled by default. When a users selects a feature definition from the list, they expect that is what will be used for civil elements.

Persist Snaps and Rule Icon in the Feature Definition Tool Bar looks very similar to Keypoint Snap icon in Snap Mode toolbar. Change the icon for Persist Snaps and Rule to include a ruler symbol with a snap point.

Currently there is no way to use end condition exceptions and as an override switch between other end conditions within a certain station range. A simple addition to the override feature where you could temporarily change the priorities of the end...

Open Roads Deed Writer user input for the same user variable used multiple times in the same phrase should only have to be entered once by the user.