Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1386 of 1386

Design Footing with sides that are parallel to the column sides

Some tight geometric conditions require a this scenario
about 1 year ago in OpenBridge Designer 0 Future consideration

It would be benefitial to allow drainage designers in ORD Drainage to use graphical elements in combination with terrains to define time of concentration components.

Currently, in order to determine one of the components of the Time of Concentration (Tc), ORD DU users have to jump completely out of the 'Catchment Properties' interface to determine the length and slope of the Tc element (since once you are in t...
about 1 year ago in Drainage and Utilities 0 Future consideration

Add ability to create an Event Point list in the OpenRoads Designer SDK.

I would like to programmatically create a new EventPoint list for an alignment. Looking through the Bentley.CifNET.GeometryModel.Tools.Helpers methods, I found GetEventPointList(Alignment) that returns a List<Bentley.CifNET.GeometryModel.KeySta...
7 months ago in Geometry / OpenRail Designer 0 Future consideration

Turn on/off elements in the main dgn will change on all the sheets.

It is expected to turn on and off elements in the container file and it will reflect those changes on all the profile sheet models.
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Allow LFD substructure analysis with an LRFD Superstructure in LEAP Steel

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...
about 1 year ago in Analytics 0 Needs review

Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Store vertical/horizontal alignment of low points

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Allow user to define width of superelevation section graphic.

Currently, the graphic representing the superelevation section is hard coded to use the radius of the smallest curve in the alignment. If the radius of the smallest curve is 50 meters or more, the section width is hard-coded to 50 meters. If t...
7 months ago in OpenRail Designer / OpenRoads Designer / Superelevation 0 Future consideration

elevation analysis in profile view

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists