Ability to separate the annotation of curves and spirals for the rail cant. At present the Non-Linear setting is applying to both This is usefull to remove some clutter (especially where there is short elements like below;

Currently in annotation group, the back/ahead tangent line drawn at the PI only has the option for a fixed length. We would like the ability to draw back and ahead tangents the full length from PC to PI to PC. This could apply to both horizontal a...

There are sometime where your end condition will be different if certain roadway item existed. However, only one infinite end condition can be drawn in a template. Which for us users require creating multiple template for those different end condi...

Every command in the vertical group in the geometry tab should have a checkbox inside to automatically make it the active one. This way the user won't have to open the profile in a view and select it. Pretty simple and would save a lot of work..

Create a best fit vertical profile and then convert to a Profile Rule. It only creates parabolas ... we need the ability to create a circular vertical curve. The profile by Best Fit command may only utilize parabolas, but they ONLY work with circu...

now we can only annotate the cut and fill in X-section, we need to be able to annotate also the different components

Create a tool to clip an alignment at any location along the alignment that does not affect or change the stationing or the station equations even if you are clipping the beginning of the alignment.

It would be useful to be able to turn on-/off single alignments. Perhaps with a checkbox in the "OpenRail Model" section in the explorer, just like the ones in the "Feature definition" section in OpenRail Standards. This could probably be handy wi...

In the Cant Editor, there is a tool called validate data which allows you to add in your design parameters and then check against the cant the Openrail has already automatically generated. although a good tool, i just think it would be better Open...

With Inroads Survey, whenever XYZ coordinates needed to be entered for a particular purpose, a screen-pick option was always available. (see attached image) This was extremely useful. However, with ORD, changing the XYZ coordinate of any points in...