Reference setting for saved view reference attachment to synchronize "settings from design model" synchronizes the level display state from View 1 of the view group that the saved view was created from (this is often the "Default View Group"). Whe...

When using the Create Drawing Dialog to cut sheets, Plan Mode, with One Sheet per DGN enabled, the sheet dgn files are named based on what is entered in the Sheet Model Model Name field. Add a field for Sheet DGN name. The DGN name needs to comply...

Similar to the commands like "Place Temporary Vertical Dimension", have a Right Click command to enable showing the temporary elevation of a specific template point selected such as a Ditch Flowline template point, existing surface at EOP template...

The current connection region of drainage nodes are available for the side faces of node only. The software should allow the connection region of pipe/conduit from the bottom of the node.

When a dgn contains lots graphics in the active dgn and reference files, I often find it challenging to select the desired alignment for various tools (e.g. tracking, laying out sheets, etc..). to make this easier, I propose that Bentley provide a...

We need the ability to adjust the Template Drop "Interval" when using the "Apply Linear Template" Tool. Currently this option is only available for Templates which are attached to Corridors, but we need to also have it available for the "Apply Lin...

Currently there is no way to use end condition exceptions and as an override switch between other end conditions within a certain station range. A simple addition to the override feature where you could temporarily change the priorities of the end...

Open Roads Deed Writer user input for the same user variable used multiple times in the same phrase should only have to be entered once by the user.

In Create Template tools, add the ability to set a Feature Definition on an Alternate Surface.

Currently when performing a Terrain to Terrain (or pane) Volume Analysis, the only option for saving the result is to save it as a text string and place in a .dgn. It would be very helpful if there was an option so save this result as a report (id...