Please update the software so to allow modeling additional exterior beam starting at abutment and ending before support lines and the added beam not parallel to the other continuous beam for multi-span unit.

In the Deed Writer tool (accessed via Geometry > Reports > Deed Writer), after selecting the reference alignment, the next step prompts the user to identify the Right of Way boundary. Currently, the tool only accepts closed shapes for this b...

When creating named boundaries of any time, a saved view is created for each named boundary. The creation of a saved view is a method that is supposed to control the look and feel of the drawing/sheet, but it is over-complicated, poorly understood...

Interface Currently, writing expressions in expression builder is only slightly better than writing code in notepad. The interface could be enhanced similar to Visual Studio with colorized classes, methods, and properties, colorized brackets with ...

Many times an alignment is partly existing and partly new or changed. In the drawings this should be shown with different symbology and annotation, something that is not easy in ORD. A tool that can do this would be very useful!

Ability to annotate the slope between two linear features in plan. Currently we can only annotate station and offset but it is very common for designers to check cross slopes.

For now, the annotation of High and Low Points is very limited:# only one Low Point is detected - multiple low points are ignored# its is a linear3D annotation, and snaps on the annotations are not ruled (this intent is to be able to place drainag...

surface templates apply depth vertically, in many cases it is desired a true depth that is perpendicular to the terrain.

In legacy versions of the software, I can have the template library open on one screen, corridor modeler on another screen, and the CAD window open on a third screen. I can make/save changes in the template, make/save changes in the corridor model...

Ability to annotate superelevation transition locations (NC, LT, LR, FS, etc.) points with slope direction indicators in plan view.