In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...

There appears to be a discrepancy in wind load calculations—specifically, the gust factor of 0.85 remains different from AASHTO standards. However, the FDOT Structures Design Guidelines (SDG) 2025 now allow the use of AASHTO Article 3.8, which may...

Currently Corridor Vertical/Both Point Controls link the the specific Vertical Profile and when these get deleted, the Point Control is removed without warning. An option to set this point control to always use the Active Profile would allow this ...

This is the Feature Request to support the ability to include General Project information in the IFC. We would like to add several user-defined attributes to the IFC Site level, including "Organization Name", "Project Address", "Project Issue Date...

XSLT 3.0 introduces several new features and improvements that can enhance the development process, increase efficiency, and provide better results. Performance Improvements: XSLT 3.0 includes optimizations that can significantly improve the perfo...

Requirement is to annotate horizontal length of straight on profile (station end - station start). It is available in frame annotation but not along linear so annotations don't match. Only the slope length can be annotated along the linear

When you create a new alignment, break a alignment and lose the turnouts or import a geometry it would be good to be able to re-associate or change the alignment to which a turnout are associated/connected to.For instance when I´m working with a c...

Currently the Create Closed Mesh Tool produces static meshes which do not update when base elements change. When any of the base elements change, the existing meshes need to be deleted and created from scratch. We would like to see the following i...

Even if you create contours and label them the labels are lost on Terrain drop or export to DWG.

Sometimes we apply more than one drawing annotation to the same model. It would be good to have a model manager view with all the applied annotations group so that we can disable, remove or add. That way we could select what we want to remove inst...