It would be nice to see what local changes were made, to a template, before Sync'ing to library. It currently notifies user that there changes made, but doesn't show what those changes are. It is difficult to know what changes may have been made t...

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...

When utilizing civil geometry to create a parcel and then creating a Legal Description report within the Civil Reports, the software add a leading zero to a bearing of less than 10 degrees. For example, "North 07 degrees 09 minutes 12 seconds West...

Currently when only one rail alignment can be selected to output a horizontal report. Would be great if the ability to select multiple alignments and output a horizontal report at the same time. Reason: Currently have projects which contain multip...

Applicable to OpenRoads Drainage, CivilStorm, and StormCAD Bentley drainage software tries to do too much / it tries to do ALL the calculations, even if you don’t want to. There have been times I have had separate drainage models: one for inlet sp...

Our partner Dataforensics has a project with an OpenGround user, HDR where they need to plot borehole data and CPT data in OpenRoads. Seems like they were able to do this in Civil3D but are now using ORD and want to do the same as the attached