Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

OpenRail Designer

Showing 75

Enhancement::Additional Tool for Design of Cross over connection between Tangent & Canted Tracks

I suggest improvements to Bentley OpenRail Designer for handling Cross over connections in the following scenarios: Cross over Between Adjacent Tangent Tracks: Enable a simple geometric connection between two parallel tracks without the use of Geo...
11 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

Drainage Annotation rotation based on sheet view rotation

Currently, the only rotation options for drainage annotation is constant. With alignments that are curving, our sheets must change rotation. It would save a lot of time spent manually adjusting rotation on each sheet.
8 months ago in Annotation / Drainage and Utilities / OpenRail Designer / OpenRoads Designer 2 Needs review

Ability to manage outer/inner pipe wall symbology separate from linear/profile symbology settings.

Need the ability to see wall symbology but not centerline. If the centerline symbology is set to construction class so are the inside/outside walls and they don't print. If the centerline is set to 255 the inside/outside walls do display in print ...
4 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 0 Needs review

Multiple alignment options

OpenRail now looks like it is behind the 12D Model, after removing good design functions in BRT. In OpenRail, it is hard to have multiple alignment options. For example, you can copy a horizontal design, it will carry a profile, but not cant desig...
about 1 month ago in OpenRail Designer 0 Needs review

Tool to detect corrupt preference file

In ORD especially in Drainage and Utilities, corrupt preferences lead to inconsistent results. There is currently no way to detect a corrupt preference file so that it can be removed until a user notices a error in the design which is usually too ...
about 1 month ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 0 Needs review

Unable to report on Geometric Points direction relative to an Alignment.

In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...
over 1 year ago in OpenRail Designer 2 Needs review

Point Code and number included in the regression points

The point code and number should be included in the regression points so that it can be printed out and identified when you make a regression report. If you only see the stationing and offset from the geometry you cannot separate normal track poin...
10 months ago in OpenRail Designer / Regression Analysis 0 Needs review

Sheet presentation of Drainage and Utilities nodes in plan view with annotation cells

When we initially stood up Storm and Sanitary, we had the center point presentation in plan view display a representative cell. I propose that we allow the placement through an element template of an annotative cell at the center of nodes to repre...
about 2 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 1 Needs review

Create Turnout Profile

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...
about 2 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

Vertical Alignment Editor

Geometry connector for verticals, missing vertical geometry editor is an issue for Ramboll and other similar consultancies in Denmark
3 months ago in Geometry / OpenRail Designer 2 Needs review