The existing Locate Point tool using the Traverse and Radial methods functionally does something similar, but must have 180 degrees added manually to the deflection angles to get the absolute angle.

Add the ability to target survey Feature Definitions with Horizontal Feature Constraints on Points within Templates. There is a deliverable required on surveyors to show cross sections of their surveyed surface where sections within the surface ha...

Whenever you have a Geometry and used shared line (e.g. Lots), There should be a tool to remove duplicate/overlapping lines. Its problematic if we use a special linestyle with gaps and when the two line on top of each other it will look like a sol...

I would like Geometry Points to support using parametric cells.

What I envision, would be the ability to define Math within a Text Favorite. So, let us say that "[[" would define the start of math in a text favorite. A text favorite could be created in that the value displayed, is math from element properties....

It would be nice to be able to export a drainage network into 2D linework that can be edited for plan sheets. Currently, we don't use our modeled files directly in our plan sheets as we cannot adjust the conduit line styles and it takes longer to ...

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

When creating parcels in Geometry Builder, I would like the option to have it automatically add COGO/Geometry Points at the PIs and on-alignment points as I place the elements.

Pipe standards vary their minimum and maximum pipe cover values based on the size of the pipes. There needs to be an ability to set this per conduit size so that when running a design you can consider these different cover depths. As of now, you w...

In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows: ...