The name of the nodes are defined at placement by the selected Feature Definition. It's common for it to be changed during the design process. For these cases, all altered nodes must be manually renamed. This usually is done through selection or u...
The current connection region of drainage nodes are available for the side faces of node only. The software should allow the connection region of pipe/conduit from the bottom of the node.
Add profiles from different horizontals to a rollplot sheet
Would like an easier way to add multiple profiles to a single sheet that belong to different horizontal alignments. Specifically we're looking for a way to quickly place all the drainage profiles (which below to different horizontal alignments) on...
OpenBridge does not seem to have a dedicated functionality for drainage system. I have seen solution in OpenBuildings, it looks quite decent. Just to clarify, when I refer to a drainage system, I mean elements like drip pipes, scuppers, vertical p...
Additional command/tool in Openroads for deleting segments/s in horizontal alignment with profile
This will be helpful especially when the certain alignments are very long, and you only need to trim segments. Currently, the viable workaround is to copy that alignment and use either Project Profile to Element tool to join the vertical alignment...
0
Needs review