Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

Geometry

Showing 168

Modify circle in complex geometry by center point

In complex geometries it does not seem to be possible to move the center point of a circular curve. When working with different alternatives, it´s common to have two geometries that shares some part of a circular curve with different start or end....
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Improve civil geometry constraints

Provide an option to quickly apply combined horizontal and vertical constraints to geometry elements. Where geometry lines (breaklines) intersect, they need to share a common elevation. The current process requires creating profile intersection po...
over 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add Create 3d Automatically Options

The Create 3d Automatically in the Feature Definition toolbar has the potential to be really powerful. Add the ability to have other options. The one I would most like to see is "Profile from Surface" based on vertices, locked to start and end.
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Add "Auto Activate Profile" to Feature Definition Bar

Add a toggle to activate the next profile that is drawn rather than having to manually activate most profile lines.
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Existing Top of Rail Elevations

Needs a more efficient way to annotate existing top of rail elevations in a profile view.
over 2 years ago in Annotation / Geometry / OpenRail Designer 2 Future consideration

Display A parameter (not Length) after using "Create Civil Rule Feature" option.

When I create an alignment with curves using A parameter and when I select this alignment "A parameter" will be properly displayed. Then when I "Remove Rule" and use "Create Civil Rule Feature" tool, A parameter will be replaced with "Length".
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add extra Coloum which shows Delta Value in Geometry Report at PC, PT, No Curve PI, SC and CS

Alerts users to the existence of "kinks" in horizontal alignments. These "kinks" are where the back and ahead tangents at PCs and PTs of curves are not on the same bearing. There is a small tolerance built in to eliminate rounding errors.
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration

Snap to specific chainage in Plan

In PRT it was possible to snap a smart line to a specific chainage in plan by using the key-in 'SO=xxx'. In OpenRail the closest tool I can find is Civil Accudraw with station-offset toggled on, but I have found that often CivilAccudraw does not w...
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Allow Vertical Scale in Profile View to Stay Set after "Saved Settings" Or Change Default to 1

Currently, if you change the vertical scale in a profile view, it always reverts back to a vertical scale of 10 if you switch the view to display the profile of a different Line. It would be much better if the scale in the view would stay at whate...
almost 2 years ago in Geometry / OpenRoads Designer 0 Already exists

Ability to Change Feature Name of Element Within Complex Element

I would like the ability to change the Feature Name of an element that is part of a Complex Element without having to drop the Complex Element.
almost 2 years ago in Geometry / OpenRail Designer 0 Already exists