Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

My ideas: Geometry

Showing 160 of 1377

Add ability to create an Event Point list in the OpenRoads Designer SDK.

I would like to programmatically create a new EventPoint list for an alignment. Looking through the Bentley.CifNET.GeometryModel.Tools.Helpers methods, I found GetEventPointList(Alignment) that returns a List<Bentley.CifNET.GeometryModel.KeySta...
7 months ago in Geometry / OpenRail Designer 0 Future consideration

Add extra Coloum which shows Delta Value in Geometry Report at PC, PT, No Curve PI, SC and CS

Alerts users to the existence of "kinks" in horizontal alignments. These "kinks" are where the back and ahead tangents at PCs and PTs of curves are not on the same bearing. There is a small tolerance built in to eliminate rounding errors.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

elevation analysis in profile view

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Allow entering a degree of curve (d 00^00'00") as the Radius of the Alignment Table Editor.

When creating curves, an ORD user is allowed to enter a degree of curve (d 00^00'00") as the Radius. Put the same functionality in the Alignment Table Editor.
7 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Allow Vertical Scale in Profile View to Stay Set after "Saved Settings" Or Change Default to 1

Currently, if you change the vertical scale in a profile view, it always reverts back to a vertical scale of 10 if you switch the view to display the profile of a different Line. It would be much better if the scale in the view would stay at whate...
over 1 year ago in Geometry / OpenRoads Designer 0 Already exists

Ability to Change Feature Name of Element Within Complex Element

I would like the ability to change the Feature Name of an element that is part of a Complex Element without having to drop the Complex Element.
over 1 year ago in Geometry / OpenRail Designer 0 Already exists

Geometry builder fix components

As in the geometry connector, the geometry builder needs to be able to fix certain elements
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Horizontal and vertical geometry - edit vertical elevations/profile in plan view, improve geometry snap rules/constraints.

We have used the horizontal and vertical geometry tools to create terrain models for site design of rest areas. We have found this to be very inefficient and time consuming. For example, the rest areas typically have sidewalks that vary in width, ...
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Geometry Builder Interior Angles

We often get plats that have interior angles and distance for the parcels, tracts, etc. It would be nice if this option was in geometry builder.
about 1 year ago in Geometry / OpenRoads Designer 0 Future consideration