Add the ability to take surface templates into account when analyzing volumes between two terrain models. That way you will not have to create a delta terrain, for instance when you want to take the clearance of top soil into account. This option ...

Possibility to add/remove/change length of long sleepers sets in turnouts that are placed in a geometry. When you are working with existing geometry and there are turnouts with too long sleepers sets or if you by mistake place a turnout that has a...

Survey chains (when enclosed) have a reported area value of zero. This is seen in the properties for the geometry, and also if you try to read the area through an item type using the expression This.GetElement().EnclosedArea. Our construction staf...

This product idea is requesting for the capability to modify the symbology of roadway templates to display as "existing" (grayed out or dashed linework) in order to distinguish proposed roadway elements from existing infrastructure in ConceptStati...

In ConceptStation, the entire roadway model is in the same display category (Road) such that it is not currently possible to turn on/off specific components of the model – for example, cut/fill sideslopes. This product idea is requesting for diffe...

In ConceptStation, superelevation rates are automatically applied based on design speed of the roadway. However, this product idea is requesting an enhancement capability to apply a desired superelevation rate to the roadway independent of the rat...

Have the ability to create Civil labeler with a null Target. This will give user the ability to create label for features/lines to use from one tool and one source. Further enhancement would be able use an expression that would change the label(ca...

Would be nice to have an option to run an 'drawing model annotation' for specific models rather than just all or one. This could be helpful for cross section annotation if we want to use different annotation groups for different ranges of the cros...

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...

Existing cant annotation is often, if not always, required on profile drawing. Actually we must project rails onto the profile, create aliases, to extract level differences between existing rails whereas the information is fully available from reg...