We often get plats that have interior angles and distance for the parcels, tracts, etc. It would be nice if this option was in geometry builder.

Enhancement Request to provide highlighting or red text for the following note to better stand out when value is non-zero.

In profile view, the top of Transition Node is tied with group elevation; and bottom elevation meet the pipe. Any chances to make the only “Transition Node” showing as “point” or “line” only in Profile? J ust only one point in the invert? Setting ...

We have had several profiles views disappear from our sheets and have had to recut the sheet. Would be nice to be able to manually attach the profile back to the sheet.

Currently we have generic pipes (ie RCP Class III) and on placement, the user defines the size by using the description field. Because of this, I cannot attach an Item Type and explicitly set the Pay Item information. If I can set what the size of...

TDOT doesn't encase the beams inside of the pier diaphragms. TDOT places an 18" diaphragm between the beam ends with bent-up strands being used for anchorage into the diaphragm. If the bridge is skewed, the diaphragms are skewed at a different ang...

Allow user to pre-set default Unit Cost in Component Quantities for the corridor

Having the ability to create a corridor without needing a vertical can be helpful when a project involves widening. With widening, I wouldn't need a profile along the CL, but instead it would be along the EOP. Point controls can be used to attach ...

LEAP Concrete defaults PCI Bridge Design Manual Table 8.7.1-1 for the deflection multipliers. However, in the same section, it is indicated that the composite multipliers given in the table are not properly account for the significant effects of a...

This would be extremely helpful in final deliveries to clients reports, providing them with statistice they need.