Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1652

Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Store vertical/horizontal alignment of low points

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

new variable for Drawing Seed lists

When using drawing seeds to define named boundary limits, all of the drawing seeds available from the variable MS_DGNLIBLISTDRAWINGSEEDS are listed. This would include both the Plan version and the Profile version of a Plan&Profile sheet. This...
almost 3 years ago in Workspace 1 Already exists

Ability to control the cl profile (in a template/corridor) by vector offset method from adjacent corridors on either side.

I would like to control the elevation of my centerline point (point in template) to be controlled by a "vector offset method" by selecting to points (corridor feature) in two corridors that running parallel.
11 months ago in Modeling / OpenRoads Designer 5 Already exists

elevation analysis in profile view

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Incorrect arc radius for turnout outer curve switch.

For turnout annotation, we need to add turnout with LLS Extension from the library. I know that it is possible to add LLS radius value for a defined curved turnout in the library, but for a complex project where there are a lot of curved turnouts ...
11 months ago in OpenRail Designer / Turnouts/Crossings 0

No subtraction of sleepers from ballast in corridor report

Corridor report does not subtract the volume of sleepers we added to the model from the ballast. I propose to add in the next version of ORD the possibility to subtract in the ballast the added sleepers.
11 months ago in OpenRail Designer / Reports 0 Future consideration

No possibility to set the lower limit height of the profile

When creating profiles using ,,Named Boundary”, I cannot set the lower height limit of the profile. I propose to add in the next part of ORD setting the lower height limit if we want to make one drawing sheet from profile. This would help with the...
11 months ago in Drawing Production / OpenRail Designer 1 Already exists

Frame action or double curvature to be considered when superstructure is integral with substructure

When a superstructure is integral to substructure for Leap Concrete, both girders in the superstructure module and columns in the substructure module analysis/ design should incorporate frame action for any design load cases such as breaking force...
11 months ago in OpenBridge Designer 0 Future consideration