Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

All ideas

Showing 142

Utility Overhead Conduits- Need Vertical Sag

Can the Overhead conduits be set to apply "sag " curves for models in 3D? which means, we will need to include vertical curves when placing them between 2 nodes (eg. poles); In a real world, the conduits typically have some sag, and not as straigh...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Add an end element in xml file

To make it easier to select and report the end of an alignment it would be good to have an "Alignment End point" or "Alignment end element" in plan and profile. Also in cant!
7 months ago in Reports 0 Needs review

Allow LFD substructure analysis with an LRFD Superstructure in LEAP Steel

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...
over 1 year ago in OpenBridge Designer 0 Needs review

Hide underground and above ground pipes and equipment

Using OpenSite Designer, is there a way to hide items, i.e. pipe, valves, and equipment, below a surface? These components are on multiple elevations above and below this surface. All components are on the same level, i.e., WATER. Client does not ...
about 1 year ago in Modeling / OpenSite Designer 2 Needs review

ORD D&U - Import / Export WaterCAD models

Ability to import /export to network data from/to OpenFlows WaterCAD in order to collaborate with BIM workflows.
about 1 year ago in Drainage and Utilities 0 Needs review

More decoration features for plans production

We need additional 2D decoration feature definitions for better control in plans production, specifically for barrier and drilled shafts
almost 2 years ago in OpenBridge Designer / OpenBridge Modeler 0 Needs review

RM Bridge update to use the correct AASHTO reduction factor for reinforced/prestressed concrete based on tensile strain in reinforcing at ultimate limit state.

The current RM bridge ultimate capacity calculations allow for material reduction factors only, which are not used by AASHTO for reinforced and prestressed concrete. AASHTO concrete reduction factors for flexure and P-M capacities are based on the...
about 1 year ago in OpenBridge Designer 0 Needs review

Toggle Drainage Calculations On or Off

Applicable to OpenRoads Drainage, CivilStorm, and StormCAD Bentley drainage software tries to do too much / it tries to do ALL the calculations, even if you don’t want to. There have been times I have had separate drainage models: one for inlet sp...
8 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Ditches be channel features

It would be wonderful if ditches were channel features so that they could be treated as surface features like gutters are to get head on inlet.
about 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Custom Grate Spacing and Sizes

It would be amazing if we could utilize our own grate spacing for calculating the head on inlets. KYTC has several grates that don't quite match with what is in the delivered system, and this may affect the depth of the head on the inlet.
about 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review