It would be very helpful if there was a way to simply Add a Conduit to an existing Profile Run. For example, I have a storm network modeled and a bunch of drawings created by using a Profile Run, but now I needed to add another conduit at the end ...

Often times a small edit is needed to make an existing abutment or pier template match project standards. It is tedious to create a Functional Component from scratch for small edits. It would be helpful to have a tool or button to export a templat...

We have the ability to create multiple profiles from multiple surfaces at the same time, but there are occasions where I only need to define a single profile line based on multiple surfaces. It would be handy if there was an option to create a pro...

I'd like to be able to add shear studs on Cross-Frames (specifically Built-up End Diaphragms).

Currently ORD will create a top mesh and bottom mesh when a template is assigned to a corridor. However, when a template is assigned to a design non-corridor terrain, no top or bottom meshes are created. Doing so would be very useful for viewing o...

It would be extremely useful to have Analyze Point on every tab by default. That tool gets utilized a lot to evaluate all kinds of civil geometry.

Currently Corridors and Linear Templates are very poorly sorted in Explorer. These need to at least be sorted alphabetically to allow users to easily find the Corridor/Linear template they are looking for. Our major projects have dozens and dozens...

Not sure why it does this, but it doesnt make sense that the software processes when these are changed although they are disabled. To aid in productivity, especially for large corridors, the corridor should check if the Point Control / Parametric ...

I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.

When we create cross sections for culverts, the cross section often needs to be created at a skew from the centerline. We are able to create these using the 2 Points option. This option, however, is limited. We would like for our cross sections to...