Users often make changes to the different fit options in the Dynamic XS view that are not persisted when the file is closed or a section via datapoint is issued (Fit Section / Center Backbone / Center on Current Offsets). It defaults back to the F...

When selecting text to be edited, the editing window will appear but the text does not get highlighted. The text has to be selected every time for changes. If all of the text being edited could be automatically highlighted like it is in the older ...

Currently when using the "Create 3D By Slope To Target" Tool, ORD seems to only project a point at every vertex of a 3D line string. This is fine when using the Geometry Tools to create 3D line strings since it creates a vertex point in 3D based o...

It would be beneficial to have the ability to specify surface math logic - Above Existing, Below Proposed, and Below "Floodplain" (variable plane) to get good floodplain volumes.

TxDOT likes to see driveway P&P’s side by side on a single sheet (see attached example), and when the workspace didn’t have a sheet seed that accommodated this type of configuration we created one ourselves. The main issue is placing both driv...

We were previously able to drop a border cell in any file to easily be able to print and now it is not

When exporting a model to IFC it is possible to export the model splitting to Named Boundary Groups. This is very powerfull because you can split your model and the volume reports in smaller parts. It would also be good if you can split the dgn to...

It would be useful to allow editing of contours after a terrain model is created. Call it "Contour Edit Mode" and allow users to massage contours in areas and preserve these edits similar to how ORD now remembers triangle edits in 10.12.

Rather than creating a new cross sectional named boundary, it would be convenient for the saved views to synchronize with 3D reference window and level display. There could even be a feature to toggle this feature on and off for a saved view.

Currently it is not possible to export the alignment and profile from Profile Run with same station as it considers the nodes in the profile. We can select the conduit and export it, but this would be actual conduit length not the center to center...