A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...

A feature would like to be added by having a control on whatever the user decides to show when you hover an element. In the current OpenRoads designer, it is only limited to both Context Toolbox and Pop-up info or none of those will appear.

Within the Table Editor tool, provide the designer the ability to graphically edit the profile while simultaneously locking any particular VPI or grade in proximity to where they wish to make a change. This was an awesome feature in Vertical Geome...

Currently in ORD 10.11, plan Named Boundaries can be utilized as a reference allowing a user to create drawing and sheet models from another .dgn file. However, this is not possible with profile Named Boundaries. Within the file where the user wis...

This command would allow for a profile to be generated for horizontal geometry with at least two intersecting points. Steps Involved: 1 -Locate Element to Profile [Main Element] 2 -Locate Element Which Intersect (Multiple Selections possible but a...

Feature Definition Toolbar A proposal for improving/expanding this feature Choosing Feature Definitions is a frequently used feature in OpenRoads Designer. Especially in urban projects, switching between pavement types, curbs, placing signs, s...

While modeling complex projects there has been many instances where I would like templates to not connect features between drops. My current workflow is to create a new corridor at these locations. One example is when a new roadway base course sec...

For modeling corners that is harder to do with templates, similar to Civil 3d, the ability to quickly manipulate elevation points and slopes on a 3d wireframe design would make designing curb ramps so much easier.

Currently, when one uses the create regression line from rails tool, the points that the program creates are 2D, in other words they contain only X and Y, not Z. It would be nice to create points along with the regression line that contains also i...

Currently we can generate the cant report with an specified interval. The issue with these report is that the exact station at which the speed changes can be interpreted incorrectly. for example. Consider an alignment in the with 100mph speed, dro...