Need the ability to report a partial quantity for an item type. For example, I can use this.GetElement().LinearElement_Length to calculate the length of an element. But I cannot report part of the length with a fence or border. My only options in ...
Allow the use of multiple Horizontal Feature Constraints in Point Properties
The ability to target multiple Horizontal Feature Constraints for a template point and set priority on those individual Features. Similar to Target Aliasing.
Temporary dimension of elevation in dynamic cross section
Add the capability to see the elevation of a point(s) on a dynamic section with a temporary dimension, much like the width/height and slope is available with horizontal and vertical temporary dimension lines.
It would be beneficial to project multiple profiles that are parallel to each other in one profile grid. For instance, one for Left front face of a curb, another for Construction Centerline, and another for Right front face of curb.
The current connection region of drainage nodes are available for the side faces of node only. The software should allow the connection region of pipe/conduit from the bottom of the node.
One issue I've found with the trace slope is that the direction is adjustable (can be down or up) and ORD isn't smart enough to change the direction of the line. This causes two issues: 1) One of your flow directions is going to be wrong, dependin...
Use 3D Element Elevation when using Edit Terrain > Insert Vertex
When inserting a vertex on a terrain using the edit tools, the vertex is put at 0 elevation (if outside the terrain) and at the terrain elevation (if inside the terrain) even if you snap to a 3D element. The current workaround requires moving the ...
Currently, The 3D cut does not work on the closed alignment's profile model. This is required specially in the case of Roundabouts. We can not create a 3D cut on the Roundabout profiles.
0
Future consideration