Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...

There’s a need for improved interoperability between OBM and LBC when working with concrete diaphragms in open or closed box beam configurations. Specifically, the transfer of diaphragm data—such as start, end, and interior diaphragms—for box gird...

In eigenvalue analysis of repetitive structures—where identical sub-systems exist independently within a single model—the same frequencies and eigenmodes are often assigned repeatedly to each sub-system. This leads to an issue with the CQC (Comple...

The current beam hog modeling behavior is not as expected. While deck thickening can be applied, the supporting beams remain straight and do not conform to the underside profile of the deck. In reality, the beams should follow the curved shape of ...

LBS V22.00.02.19CS0035224 Service Case 1233802: [CS0035224] The fatigue stress range calculation doesn’t follow as per AASHTO Table 6.6.1.2.3-1, Section 7.2 Product Backlog Item 1233801: (VM):LBS:V22:The fatigue stress range calculation doesn’t fo...

I am attempting to model a 3 span concrete slab bridge with thickened haunches over the supports. I am using a typical deck template. My thickness variations are shown in the first attachment. The Bridge has a 10 degree skew angle at the supports....

At the moment, you run Place Node, then set the type of node by picking a feature definition. However, you normally know what type of node that you want to place, such as a manhole for example,so it would be more intuitive if the ribbon contained ...

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...

Currently, when importing text files to fieldbooks the directory opens in the last used directory. It would be useful to control this behavior so that it can open in the directory where the active DGN is located. This can function similar to the c...

OpenRoads should have a Command that place a line between two imported points (.asc, .crv, .txt file) V8i does have a command that will place a line between two imported points. After importing the points into the drawing, you click on the "line c...