In Geopak, we had the ability to take individual alignments and create an overall alignment from a subset of alignments and it would hold the individual stationing for each alignment, creating station equations. There is no way to do this in ORD u...

Currently this option is only available for Linear features. This means any text annotated through Point annotation groups can't be moved or rotated, which is a problem for our Right of Way points. Sometimes we have 100+ Right of Way points that r...

When laying out watermain pipes the bends can be 45 degrees, 22.5 degrees, etc. These bends are modeled as nodes in our workspace so we can report of them and display them in our drawings. If the angle of the pipe adjusts, we want the node feature...

The existing Locate Point tool using the Traverse and Radial methods functionally does something similar, but must have 180 degrees added manually to the deflection angles to get the absolute angle.

Whenever you have a Geometry and used shared line (e.g. Lots), There should be a tool to remove duplicate/overlapping lines. Its problematic if we use a special linestyle with gaps and when the two line on top of each other it will look like a sol...

I would like Geometry Points to support using parametric cells.

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

What I envision, would be the ability to define Math within a Text Favorite. So, let us say that "[[" would define the start of math in a text favorite. A text favorite could be created in that the value displayed, is math from element properties....

It would be nice to be able to export a drainage network into 2D linework that can be edited for plan sheets. Currently, we don't use our modeled files directly in our plan sheets as we cannot adjust the conduit line styles and it takes longer to ...

When creating parcels in Geometry Builder, I would like the option to have it automatically add COGO/Geometry Points at the PIs and on-alignment points as I place the elements.