Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

OpenRail Designer

Showing 834

Add reflect option for DU cells.

Implement a way to minimize the number of cells by allowing reflecting and mirroring of nodes during placement and manipulation.
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to lock Parametric Constraint Start/End to XY or Stations

There are many different situations where users may want Parametric Constraints to be locked to specific stations or XY locations. An additional column in Corridor objects with this option would be very valuable for users to identify and control d...
about 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer 1 Future consideration

Corridor Template Feature Definition override

I want to show in our corridor models the areas where we are using erosion control measures vs using general seeding. Currently, the only real way to make this distinction is to either create a new template that uses a different feature definition...
2 months ago in Modeling / OpenRail Designer / OpenRoads Designer 0 Future consideration

Show external references in Target Aliasing

Ability to add a profile elements of an alignment as an external references when using the Target Aliasing command.
10 months ago in Modeling / OpenRail Designer / OpenRoads Designer 0 Future consideration

Regression: add a "Remove regression points" command both for H and V regression line

We can add points to regression line but we can't remove points from regression line.We can ignore but it is not good management especially if you added a wrong point to the regression line that must be added to another regression line. Because th...
about 2 years ago in Geometry / OpenRail Designer 1 Future consideration

Allow "Save Settings" to save your preferred default settings in the Feature Definition Tool Bar

Many users prefer different settings to be selected by default in the Feature Definition Tool Bar. Currently, "Persist Snaps and Rule" is always ON by default when opening a file but nothing else. Even if you turn this off, or activate another set...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

MVD is not defined when exported to IFC

In IFC Export, there is NO Model View Definition in exported IFC.
10 months ago in Import/Export / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Label all the points in a superelevation section with Civil Labeler

Superelevation is a tabular note that goes on the general info sheet with the super elevation diagram, so we usually just fill out the info in that tabular note. Designers just blow up the tabular note to add lines and make it work per project. If...
over 1 year ago in Annotation / OpenRail Designer / OpenRoads Designer / Superelevation 0 Future consideration

Parallel snap with Civil horizontal line

When creating centerline geometry you may need it to be parallel to outside boundaries like Right of Way. It would be convenient to be able to select that snap and use it like it works for MicroStation lines.
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Create Template Geometry - Option to create 2D Elements from points located below top surface

Currently only template points located on top surface can produce 2d linear elements. This also only seems possible, when the components they belong to, are not ‘Excluded From Top/Bottom Mesh’ (option in Component properties dialog) and the ‘Creat...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration