Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

OpenRail Designer

Showing 1158

Unable to report on Geometric Points direction relative to an Alignment.

In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...
over 1 year ago in OpenRail Designer 2 Needs review

Annotate Horizontal length along straight on profile

Requirement is to annotate horizontal length of straight on profile (station end - station start). It is available in frame annotation but not along linear so annotations don't match. Only the slope length can be annotated along the linear
over 2 years ago in Annotation / Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add Corridor/Linear Template Vertical & Both Point Controls "Active Profile" option

Currently Corridor Vertical/Both Point Controls link the the specific Vertical Profile and when these get deleted, the Point Control is removed without warning. An option to set this point control to always use the Active Profile would allow this ...
almost 3 years ago in Modeling / OpenRail Designer / OpenRoads Designer 1 Future consideration

Add Color Coded Surface tool from InRoads to OpenRoads Designer.

The Color-Coded surface tool is missing in OpenRoads Designer which was there in InRoads, We can use the Thematic Height Display Style but that forces to use Rasterized Option while printing and in the PDF the surface gets pixelated.
almost 2 years ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 0 Future consideration

Export Terrain countours to DWG

Even if you create contours and label them the labels are lost on Terrain drop or export to DWG.
over 2 years ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 0 Future consideration

Sheet presentation of Drainage and Utilities nodes in plan view with annotation cells

When we initially stood up Storm and Sanitary, we had the center point presentation in plan view display a representative cell. I propose that we allow the placement through an element template of an annotative cell at the center of nodes to repre...
about 1 month ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 1 Needs review

Create Turnout Profile

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...
about 1 month ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

Cross Section Navigator - Alignment Associations

A user asked, "Why is it that upon closing cross cross-section navigator, users have to re-associate an alignment, pick a viewport to display the dynamic cross sections, and then data point inside this viewport to get the Cross Section Navigator p...
3 months ago in Modeling / OpenRail Designer / OpenRoads Designer 0 Future consideration

Point Code and number included in the regression points

The point code and number should be included in the regression points so that it can be printed out and identified when you make a regression report. If you only see the stationing and offset from the geometry you cannot separate normal track poin...
10 months ago in OpenRail Designer / Regression Analysis 0 Needs review

Re-associate turnout to an alignment

When you create a new alignment, break a alignment and lose the turnouts or import a geometry it would be good to be able to re-associate or change the alignment to which a turnout are associated/connected to.For instance when I´m working with a c...
over 2 years ago in OpenRail Designer / Turnouts/Crossings 1 Planned