In modeling a gore area, I need the slope direction to follow an auxiliary alignment. However, when using corridor information from OpenRoads Designer (ORD), it becomes incompatible with OpenBridge Modeler (OBM) if there's a change in slope direct...

For final bridge plans involving a steel bridge, we need to report dead load deflections at either the 10th or 20th points along the span—from bearing to bearing. While the program does calculate these points, it currently measures them from the e...

Need new Barrier Feature definition separated for Deck & Approach Slab.

The class of a pipe is primarily selected by the depth of cover over a pipe. Sometimes vehicle loads or construction loads have an influence on the class selection

This would be very similar to the way that OBM creates and manages bents, columns, footings, etc. This would allow for more rapid population of custom vertical sign items in our 3D design environments. By this I mean items of different sizes, span...

The XS annotation group will place annotations in text conflicting locations. Once the user resolves the text conflicts there is a chance that the annotations may have to be revised when the model is updated. Therefore, it would be helpful if ther...

If you check the "Do not Show Again" box and press OK to the warning message in OpenRoads SignCAD 2023, then you can add additional panels to the file without the warning message displaying. However, closing and reopening the file will cause the m...

when creating a new survey point or geometry point, I would like an option to get the elevation of the point XZ from a terrain.

Add ability to create speed table based on minimum-maximum cant/cant deficiency and curvature.

As a light rail design engineer I want to produce profiles with a lot of information to be able to check a maximum amount of information on a single document.On critical information for light rail design is the maximum speed. This is because light...