Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

OpenSite Designer

Showing 789

Dynamic Cross Section View - Retain User Settings

Users often make changes to the different fit options in the Dynamic XS view that are not persisted when the file is closed or a section via datapoint is issued (Fit Section / Center Backbone / Center on Current Offsets). It defaults back to the F...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration

Flood Volumes - Surface analysis between three surfaces

It would be beneficial to have the ability to specify surface math logic - Above Existing, Below Proposed, and Below "Floodplain" (variable plane) to get good floodplain volumes.
about 1 year ago in Analytics / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 1 Future consideration

In the Create Template editor add a list similar to the Point Name List for Components

This would enable users to quickly edit the component feature definitions for templates in the library.
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add the ability to place banks of conduits.

Electrical and Communications conduits are usually placed in banks of multiple conduits of say 12 conduits which may be of different sizes.
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

ITL Copy Components

Add ability to copy points, components and sets of components
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Selection of named boundary with different associations

TxDOT likes to see driveway P&P’s side by side on a single sheet (see attached example), and when the workspace didn’t have a sheet seed that accommodated this type of configuration we created one ourselves. The main issue is placing both driv...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to print without needing to go through named boundaries

We were previously able to drop a border cell in any file to easily be able to print and now it is not
about 1 year ago in Drawing Production / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRail Overhead Line Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Already exists

Calculation Summary ("Report") Improvement Suggestions

The calculation executive summary and calculation detailed summary would be improved by adding a time stamp near the date and file name at the bottom of the reports' pages. It would be helpful to be able to add a note to the reports describing tha...
5 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

GenerativeComponents - Feature Definition tool Node

Special Node/Option for Full recognition (reading civil information) and creation of Feature Definitions in GenerativeComponents. GC & Civil Packages would benefit greatly if we could automate the creation of Civil Lines (2D/3D) for subsequen...
over 1 year ago in Modeling / OpenBridge Modeler / OpenRail Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Ability to flip/reverse cross sections around baseline.

Ability to flip/reverse cross sections around baseline. Currently, when you reverse section, it does not hold station 0.
over 2 years ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration