When the bridge needs a long “wingwall”, it break two part – a wingwall which is built with the abutment, and the rest part I call it “Retaining wall”. Is it possibly to make this retaining wall as easy as wingwall? That means like put the wingwal...

Create an Easy civil cell for turn-out edition and turn-out annotation

This improvement would use graphic symbols (construction elements) to represent constraint relationships in plan view. For horizontal elements that are snapped, there are the snap glyphs that show that there is a relationship, but there is not a w...

Ability to insert a series of event points, e.g., every 25 m along axis, in a single shot at once

For the water supply project, in a situation where we have cast iron elements connected to the flange such as gate valves, hydrants, elbows, venturiers and plastic line pipes. There is no way to connect the two nodes directly through the flange. a...

As a Highway Engineer, I want the horizontal alignment reports to show deflections at PIs even if there is no curve, at least one of the reports so that I don't need to add it manually.

now we can only annotate the cut and fill in X-section, we need to be able to annotate also the different components

For large scale projects, earthwork volumetric meshes cause considerable deficits in navigation performance due to the high count of vertices and faces to be calculated with each navigational operation. Use of scalable meshes for these components ...

When designing drilled shafts, there is no option to display controlling shear and moment loads (bottom of column). This is needed for the geotechnical engineer on designing th drilled shaft. For column design, it is sometime useful to also show c...

It could be useful for different purposes to be able to create component meshes of defined length (construction, pre cast slab). I suggest to add at least 3 parameters to any component: length of the component: the question is then, where to measu...