Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

OpenRoads Designer

Showing 915

Flood Volumes - Surface analysis between three surfaces

It would be beneficial to have the ability to specify surface math logic - Above Existing, Below Proposed, and Below "Floodplain" (variable plane) to get good floodplain volumes.
about 1 year ago in Analytics / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 1 Future consideration

In the Create Template editor add a list similar to the Point Name List for Components

This would enable users to quickly edit the component feature definitions for templates in the library.
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add the ability to place banks of conduits.

Electrical and Communications conduits are usually placed in banks of multiple conduits of say 12 conduits which may be of different sizes.
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Selection of named boundary with different associations

TxDOT likes to see driveway P&P’s side by side on a single sheet (see attached example), and when the workspace didn’t have a sheet seed that accommodated this type of configuration we created one ourselves. The main issue is placing both driv...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Calculation Summary ("Report") Improvement Suggestions

The calculation executive summary and calculation detailed summary would be improved by adding a time stamp near the date and file name at the bottom of the reports' pages. It would be helpful to be able to add a note to the reports describing tha...
5 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to flip/reverse cross sections around baseline.

Ability to flip/reverse cross sections around baseline. Currently, when you reverse section, it does not hold station 0.
over 2 years ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to Include Profile when off setting 2D Geometry

It would be much more intuitive and beneficial if there was an option to "include" the profile of a geometry element when using the Offset Tools. Currently, the workflow is to offset the 2D geometry, and then copy the Profile from the reference ge...
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Graphics should be excluded from being made part of a complex alignment

If a grahic, a constuction line for example, is touching an alignment element, it will be included in the alignment when the "automatic" funtion is used in Create Complex Geomtery tool The create complex geomtry tool should only take into account ...
over 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Needs ability to set RIM Depression Depth

Needs ability to add RIM Depression Depth with elevation (ground). Currently we can only set the Elevation (RIm) but not any depression value.
over 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration