Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

Applications

Showing 121

Ability to manage outer/inner pipe wall symbology separate from linear/profile symbology settings.

Need the ability to see wall symbology but not centerline. If the centerline symbology is set to construction class so are the inside/outside walls and they don't print. If the centerline is set to 255 the inside/outside walls do display in print ...
4 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 0 Needs review

Unable to report on Geometric Points direction relative to an Alignment.

In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...
over 1 year ago in OpenRail Designer 2 Needs review

Point Code and number included in the regression points

The point code and number should be included in the regression points so that it can be printed out and identified when you make a regression report. If you only see the stationing and offset from the geometry you cannot separate normal track poin...
11 months ago in OpenRail Designer / Regression Analysis 0 Needs review

Request for Sideslope End Condition Targets Between Multiple Roadway Alignments in ConceptStation

This product idea proposes an enhancement to ConceptStation that would allow the sideslope end conditions on multiple roadway alignments to target each other to prevent overlapping slopes. Currently, this is only possible with the intersection, ro...
over 1 year ago in OpenRoads ConceptStation 0 Needs review

Multiple alignment options

OpenRail now looks like it is behind the 12D Model, after removing good design functions in BRT. In OpenRail, it is hard to have multiple alignment options. For example, you can copy a horizontal design, it will carry a profile, but not cant desig...
about 2 months ago in OpenRail Designer 0 Needs review

Vertical Alignment Editor

Geometry connector for verticals, missing vertical geometry editor is an issue for Ramboll and other similar consultancies in Denmark
4 months ago in Geometry / OpenRail Designer 2 Needs review

Tool to detect corrupt preference file

In ORD especially in Drainage and Utilities, corrupt preferences lead to inconsistent results. There is currently no way to detect a corrupt preference file so that it can be removed until a user notices a error in the design which is usually too ...
about 2 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 0 Needs review

WS wind speeds table for FDOT Sdg 2.4 (and combinations) are not updated as per 2025

There appears to be a discrepancy in wind load calculations—specifically, the gust factor of 0.85 remains different from AASHTO standards. However, the FDOT Structures Design Guidelines (SDG) 2025 now allow the use of AASHTO Article 3.8, which may...
4 months ago in OpenBridge Designer 0 Needs review

Sheet presentation of Drainage and Utilities nodes in plan view with annotation cells

When we initially stood up Storm and Sanitary, we had the center point presentation in plan view display a representative cell. I propose that we allow the placement through an element template of an annotative cell at the center of nodes to repre...
about 2 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 1 Needs review

Create Turnout Profile

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...
about 2 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review