Need Support? Let’s guide you to the right answer or agent.

OpenBridge Ideas Portal

ADD A NEW IDEA

Applications

Showing 1528

Design Footing with sides that are parallel to the column sides

Some tight geometric conditions require a this scenario
almost 2 years ago in OpenBridge Designer 0 Future consideration

Unit Cost

Allow user to pre-set default Unit Cost in Component Quantities for the corridor
12 months ago in OpenRail Designer / OpenRoads Designer / Reports 0 Future consideration

Turn on/off elements in the main dgn will change on all the sheets.

It is expected to turn on and off elements in the container file and it will reflect those changes on all the profile sheet models.
almost 2 years ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Composite Deflection Multipliers

LEAP Concrete defaults PCI Bridge Design Manual Table 8.7.1-1 for the deflection multipliers. However, in the same section, it is indicated that the composite multipliers given in the table are not properly account for the significant effects of a...
12 months ago in OpenBridge Designer 0 Future consideration

Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Store vertical/horizontal alignment of low points

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

elevation analysis in profile view

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Profiles and Sections with no sheets

I am going back to the SS2 versions. I would like to see an option to produce 1 profile for the entire alignment. Give it the station range and produce the profile in Microstation with an option to annotate The same for Cross-Sections. Station Ran...
about 3 years ago in Drawing Production / Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Template Creation window access ProjectWise datasource to load xml template libraries from another project

Provide a ProjectWise datasource connection to the OBM Template Creation window to open a "Select Document" dialog. The OBM Template Creation window is unable to OPEN another XML from ProjectWise - Open dialog is currently limited to Windows File ...
about 2 years ago in OpenBridge Modeler 0 Future consideration