Dynamic Settings should use Accudraw like interface rather than HS, DL, XY etc keyins
Accudraw intelligently interprets direction from the last input point. There would be no need to enter + or - on slopes as you move the cursor and lock in direction/distances. The keins would not be necessary if the template editor functioned simi...
It is usual request to annotate 3D features on cross sections. At point or in frame. It does work when feature is 2D+3D but not if feature is 3D only. That is commong with existing ground and more and more with modelling using linear features (wit...
Option to place beam as the cell.- In the case where the beam cross section (Template) is changing quite a lot in one span, when there are other elements attached to beam, penetrations in the beam or simply complex geometry of the beam it would be...
I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.
I noticed that template ranges can overlap and there is no obvious indication that this is occurring. Ideally over lapping station ranges should highlight in red to draw attention to it.
in Drainage and Utilities, remove the Maximum Spread (global for the dgn file) and make it editable for each individual node. Roadways have lots of different gutters etc so I don't want a max spread for the whole file, I want individually.
0
Future consideration